Used Practix Laminator System for Sale

• Maximum working width of complete system 65″ (1650mm)
• Maximum outside roll diameter 65″ (1650mm) both unwind and rewind
• All unwinds/rewinds set up for 3″ cores
• Allowable material thickness of 2mm-110mm
• PSA maximum roll diameter 25″ (635mm)
• Maximum roll weight not to exceed 600 pounds
• Speed of machine 1-40 feet per minute
• Power 240V/3Phases/60Hz

Unwind with two PSA Unwinds

• Unwind with web guide system; 5″ correction from center (10″ total); up to 5″ thick
• PSA unwinds: 1 unwind to deliver PSA to the underside of the material; 1 unwind to deliver on the top ply of PSA; Each unwind with pneumatic clutch/brake to control tension
• Portable table 62″ wide and 100″ long to be used for material in sheets

Laminator Practix Model OK-300

• Teflon coated fiberglass belt to carry the product through the laminating process
• This belt is 0.018″ (0.36mm) thick
• 1 lower heating platen
• 2 upper heating platens
• Each heater platen with three-zone heat control
• The bottom heater assembly is fixed
• The upper platens are gappable from 2 mm up to 110 mm
• The front and back of each of the heater platens can be adjusted independently of each other
• The movement of the upper heating plates is achieved with a gear motor and an Acme thread The movement is controlled by the HMI
• The heating platens is constructed from 20 mm aluminum 6061 plate
• The bottom plate measures 55″ long x 74″ wide
• The upper heaters platens measure 40″ x 74″
• Silicone coated calendar rollers that travels with the upper heater platens
• The lower pressure roller is fixed
• The upper pressure roller can be adjusted
• In-between the two upper heating platens are 2 unwinds and 1 rewind with pneumatic clutches/brakes
• This allows for addition of another substrate e.g., aluminum foil
• Stop, jog and run button in the area in front of each laminating section
• This allows the operator to manage the set up on start-ups by themselves
• E stops located at convenient locations
• Loading areas with trip wire and safety gate that stop the machine in the event something trips it

Rewind system

• 2 rewinds
• Each with web guide system; 5″ correction from center (10″ total); up to 5″ thick

Human Machine Interface Control (HMI)

• 15-inch touch screen control with Mitsubishi controls.
• Can store up to 1000 recipes